Back to Contents Page
Palm-Rest Assembly
Dell Inspiron M5040/15-N5040/15-N5050 Owner's Manual
Removing the Palm-Rest Assembly
Replacing the Palm-Rest Assembly
Removing the Palm-Rest Assembly
1. Follow the instructions in Before You Begin.
2. Remove the battery. See Removing the Battery.
3. Remove the 11 screws that secure the palm-rest assembly to the computer base.
4. Remove the keyboard. See Removing the Keyboard.
5. Remove the two screws on the palm-rest assembly.
6. Lift the connector latch that secures the power-button board cable and touch-pad cable to the connectors on the system board and remove the cables.
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell is
not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: To help prevent damage to the system board, remove the main battery, see Removing the Battery, before working inside the computer.
CAUTION: Pull on the plastic tab on top of the connectors to avoid damaging the connectors.
To Next Page
Loading...
