Back to Contents Page
Thermal Cooling Assembly
Dell Inspiron M5040/15-N5040/15-N5050 Owner's Manual
Removing the Thermal Cooling Assembly
Replacing the Thermal Cooling Assembly
Removing the Thermal Cooling Assembly
1. Follow the instructions in Before You Begin.
2. Remove the battery. See Removing the Battery.
3. Follow the instructions from step 3 to step 8 in Removing the Palm-Rest Assembly.
4. Disconnect the display cable from the connector on the system board and peel the cable off the thermal cooling assembly.
5. Disconnect the fan cable from the connector on the system board.
6. In sequential order (indicated on the thermal cooling assembly), loosen the four captive screws that secure the thermal cooling assembly to the system
board.
7. Lift the thermal cooling assembly away from the computer.
Replacing the Thermal Cooling Assembly
1. Follow the instructions in Before You Begin.
2. Align the four captive screws on the thermal cooling assembly with the screw holes on the system board and tighten the screws in sequential order
(indicated on the thermal cooling assembly).
3. Connect the fan cable to the connector on the system board.
4. Attach the display cable to the thermal cooling assembly and connect the display cable to the connector on the system board.
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: To help prevent damage to the system board, remove the main battery, see Removing the Battery, before working inside the computer.
To Next Page
Loading...
