Dell Inspiron One 2205 - Understand Inspiron One Beep Codes for Errors

Back to Contents Page
 MXM Assembly (Optional)
Dell™Inspiron™One2205ServiceManual
Removing the MXM Assembly
Replacing the MXM Assembly


Removing the MXM Assembly

1. Follow the instructions in Before You Begin.

2. Remove the back cover (see Removing the Back Cover).

3. Follow the instructions from step 3 to step 7 in Removing the Front Stand.

4. Remove the rear stand cover (see Removing the Rear Stand Cover).

5. Remove the system-board shield (see Removing the System-Board Shield).

6. Remove the MXM-assembly fan (see Removing the MXM-Assembly Fan).

7. Remove the three screws that secure the MXM assembly to the chassis.

8. Remove the MXM assembly from the MXM-assembly connector.
Replacing the MXM Assembly

1. Follow the instructions in Before You Begin.

2. Align the notch on the MXM assembly with the tab in the MXM assembly connector.

3. Insert the MXM assembly at a 45-degree angle into the MXM-assembly connector.

4. Replace the three screws that secure the MXM assembly to the chassis.

WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
WARNING: The MXM assembly may be very hot during normal operation. Ensure that it has had sufficient time to cool before you touch it.
CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
1
MXM assembly connector
2
MXM assembly
3
screws (3)