Dell Inspiron One 2205 - Page 43

Back to Contents Page
 MXM-Assembly Fan (Optional)
Dell™Inspiron™One2205ServiceManual
Removing the MXM-Assembly Fan
Replacing the MXM-Assembly Fan


Removing the MXM-Assembly Fan

1. Follow the instructions in Before You Begin.

2. Remove the back cover (see Removing the Back Cover).

3. Follow the instructions from step 3 to step 7 in Removing the Front Stand.

4. Remove the rear stand cover (see Removing the Rear Stand Cover).

5. Remove the system-board shield (see Removing the System-Board Shield).

6. Disconnect the MXM-assembly fan cable from the connector (MXM FAN) on the system board.

7. Remove the two screws that secure the MXM-assembly fan to the hex nut screws.

8. Carefully peel the silver foil from the MXM-assembly heat sink.

9. Lift the MXM-assembly fan along with its cable away from the system board.
Replacing the MXM-Assembly Fan

1. Follow the instructions in Before You Begin.

2. Align the screw holes on the MXM-assembly fan with the screw holes on the hex nut screws.

3. Adhere the silver foil on the MXM-assembly heat sink.

4. Replace the two screws that secure the MXM-assembly fan to the hex nut screws.

WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
1
MXM-assembly fan
2
screws (2)
3
MXM-assembly fan cable