Next steps
1. Install the battery.
2. Install the base cover.
3. Install the SD card.
4. Follow the procedure in After working inside your computer.
Heatsink assembly
Removing the Heatsink Assembly - UMA
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the SD Card.
3. Remove the base cover.
4. Disconnect the battery.
About this task
The following images indicate the location of the heatsink and provide a visual representation of the removal procedure.
Steps
1. Loosen the seven captive screws that secure the heatsink to the system board.
2. Lift the heatsink assembly away from the computer.
Installing the Heatsink Assembly - Discrete
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
50
Disassembly and reassembly
To Next Page
Loading...
