Next steps
1. Install the WLAN card.
2. Install the WWAN card.
3. Install the Solid state drive.
4. Install the battery.
5. Install the base cover.
6. Install the SD Card.
7. Follow the procedure in After working inside your computer.
Power button
Removing the Power Button
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the SD Card.
3. Remove the base cover.
4. Disconnect the battery.
5. Remove the WLAN card.
6. Remove the WWAN card.
7. Remove the IO board.
8. Remove the solid state drive.
About this task
The figure indicates the location of the Power Button and provides a visual representation of the removal procedure.
Steps
1. Disconnect the power button connector cable from the daughterboard module.
2. Remove the two (M2x3) screws that secure the shield over the power button module.
3. Lift the Power Button module away from the computer.
Disassembly and reassembly
65
To Next Page
Loading...
