Steps
1. Place the heatsink onto the system board ensuring the mounting points on heatsink and system board align.
2. Tighten the four captive screws to secure the heatsink to the system board.
Next steps
1. Install the battery.
2. Install the base cover.
3. Install the SD Card.
4. Follow the procedure in After working inside your computer.
System board
Removing the system board - Discrete
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the SD Card.
3. Remove the base cover.
4. Disconnect the battery.
5. Remove the memory modules.
6. Remove the WWAN card.
7. Remove the WLAN card.
8. Remove the solid state drive.
9. Remove the heatsink.
About this task
The figure indicates the location of the system board and provides a visual representation of the removal procedure.
Disassembly and reassembly
53
To Next Page
Loading...
