8. Install the SD Card.
9. Follow the procedure in After working inside your computer.
IO Board
Removing the IO Board
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the SD Card.
3. Remove the base cover.
4. Disconnect the battery.
5. Remove the WLAN card.
6. Remove the WWAN card.
7. Remove the solid state drive.
NOTE: Hall Sensor is a part of the IO board and the entire IO board needs to be replaced if the Hall Sensor is faulty.
About this task
The following images indicate the location of the memory module and provide a visual representation of the removal procedure.
Disassembly and reassembly
63
To Next Page
Loading...
