6. Remove the WWAN card.
7. Remove the coin-cell battery.
8. Remove the memory modules.
9. Remove the DC-in.
10. Remove the solid state drive.
11. Remove the hard drive.
12. Remove the touchpad.
13. Remove the speakers.
14. Remove the heatsink.
15. Remove the system board.
NOTE: The system board can be removed along with the heat sink.
About this task
The figure indicates the location of the Palmrest Assembly and provides a visual representation of the removal procedure.
Steps
Once the required parts are removed, the bare palmrest assembly can be accessed and removed.
Next steps
1. Install the system board
2. Install the heatsink.
3. Install the speakers.
4. Install the touchpad.
5. Install the hard drive.
6. Install the solid state drive.
7. Install the DC-in.
8. Install the memory modules.
9. Install the coin-cell battery.
10. Install the WWAN card.
11. Install the WLAN card.
12. Install the battery.
13. Install the base cover.
Disassembly and reassembly
73
To Next Page
Loading...
