Dell Latitude 3520 - Page 108

Table 10. System setup options—Connection menu (continued)
Connection
Integrated NIC If enabled, UEFI network protocols are installed and available, allowing pre-OS
and early OS networking features to use any enabled NICs. The option Enable
with PXE is enabled by default.
Wireless Device Enable
WWAN/GPS (For systems with discrete
video card only)
Enable or disable the internal WWAN/GPS device. By default, the option
enabled. The WWAN Bus Mode option is used to set the interface type of
the WWAN card. By default, the option Bus Mode PCIe is enabled.
WLAN Enable or disable the internal WLAN device.
By default, the option enabled.
Bluetooth Enable or disable the internal Bluetooth device.
By default, the option enabled.
Enable UEFI Network Stack Enable or disable UEFI Network Stack.
By default, the Enable UEFI Network Stack option is enabled.
Wireless Radio Control
Control WLAN radio Sense the connection of the system to a wired network and subsequently
disable the selected wireless radios (WLAN).
By default, the option is disabled.
Control WWAN radio Sense the connection of the system to a wired network and subsequently
disable the selected wireless radios (WWAN).
By default, the option is disabled.
HTTPs Boot Feature(For systems with
discrete video card only)
HTTPs Boot Enable or disable the HTTPs Boot feature.
By default, the HTTPs Boot option is enabled.
Table 11. System setup options—Power menu
Power
Battery configuration Enables the system to run on battery during peak power usage hours. Use the
table Custom Charge Start and Custom Charge Stop, to prevent AC power
usage between certain times of each day.
By default, the Adaptive option is enabled.
Advanced Configuration
Enable Advanced Battery Charge
Configuration
Enable or disable the advanced battery charge configuration.
By default, the Enable Advanced Battery Charge Configuration option is
disabled.
Peak Shift Enables the system to run on battery during peak power usage hours.
Enable Peak Shift
By default, the Enable Peak Shift option is disabled.
USB PowerShare
Enable USB PowerShare Enable or disable the USB PowerShare.
By default, the Enable USB PowerShare option is disabled
Thermal Management Enables to cool the fan and processor heat management to adjust the system
performance, noise, and temperature.
108 BIOS setup