Installing the WWAN card
About this task
CAUTION: To avoid damage to the WWAN card, do not place any cables under it.
Steps
1. Insert the WWAN card into the connector on the system board [1].
2. Connect the WWAN antenna cables to the connectors on the WWAN card [2].
3. Place the WWAN card bracket with screw to secure the WWAN antenna cables to the WWAN card [3].
4. Tighten the single (M2x3) captive screw to secure the WWAN card bracket to the WWAN card [4].
Komponentide eemaldamine ja paigaldamine
29
To Next Page
Loading...
