Dell Latitude 5300 2-in-1 Chrome - Page 65

5. Connect the EMR sensor cable to the connector on the system board and adhere the adhesive tape [1].
6. Connect the eDP cable to the connector on the system board and adhere the adhesive tape [2].
7. Replace the eDP cable bracket on the eDP cable connector on the system board [3].
8. Replace the single (M2x4) screw that secures the eDP cable bracket to the system board [4].
9. Connect the touch screen cable to the connector on the system board and adhere the adhesive tape [5].
Komponentide eemaldamine ja paigaldamine
65