3. Remove the base cover.
4. Remove the battery.
5. Remove the speaker.
6. Remove the memory module.
7. Remove the system fan.
8. Remove the DC-in .
9. Remove the WLAN card.
10. Remove the WWAN card.
11. Remove the system board.
NOTE: System board can be removed with heatsink attached.
12. Remove the coin cell battery.
13. Remove the keyboard.
14. Remove the SmartCard reader board.
15. Remove the SSD
About this task
After performing the preceding steps, you are left with the palmrest and keyboard assembly.
Next steps
1. Replace the SmartCard reader board.
2. Replace the keyboard.
3. Replace the coin cell battery.
4. Replace the system board.
NOTE: System board can be replaced with heatsink attached.
5. Replace the WWAN card.
6. Replace the WLAN card.
7. Replace the DC-in.
Disassembly and reassembly
109
To Next Page
Loading...
