4. Remove the battery.
5. Remove the display assembly.
6. Remove the display bezel.
7. Remove the hinge caps.
8. Remove the display hinges.
Steps
1. Remove the two (M2x2) screws that secure the display panel to the display assembly [1] and lift to turn over the display panel to
access the display cable [2].
2. Peel the conductive tape [1] on the display cable connector.
3. Lift the latch and disconnect the display cable from the connector on the display panel [2, 3].
NOTE:
Do not pull and release the Stretch (SR) Tapes from the display panel. There is no need to separate the
brackets from the display panel.
Disassembly and reassembly 99
To Next Page
Loading...
