7. Remove the hard drive.
8. Remove the wireless card.
9. Remove the WWAN card.
10. Remove the assembly inner frame.
11. Remove the heat sink.
About this task
The following image indicates the connectors on your system board.
Figure 1. System board connectors
1. Fingerprint reader connector
2. Wireless connector
3. Memory modules
4. eDP cable connector
5. Display cable connector
6. System fan connector
7. Clickpad cable connector
8. Solid-state drive—slot 1
9. Battery cable connector
10. Solid-state drive—slot 2
11. LED cable connector
12. USH board connector
13. WWAN connector
14. Hard-drive cable connector
15. Speaker cable connector
The following images indicate the location of the system board and provide a visual representation of the removal procedure.
66
Removing and installing components
To Next Page
Loading...
