Steps
NOTE:
The system board can be removed and installed with the heat sink attached in order to simplify the procedure and
preserve the thermal bond between the system board and heat sink. In order to do so, technicians must also remove the
two screws (M2x5) that secure the system fan to the system board.
1. Slide the system board to make the USB Type-C connector to toe-in to the hinge saddle and align the screw holes on the
system board with the screw holes on the palm-rest assembly and keyboard assembly.
2. Replace the two screws (M2x3) to secure the system board to the palm-rest assembly and keyboard assembly.
3. Connect the coin-cell battery cable to the connector on the system board.
4. Connect the fingerprint reader cable to the connector on the system board.
5. Align and place the USB Type-C bracket on the system board.
6. Replace the three screws (M2x4) that secure the USB Type-C bracket to the system board.
7. Route the display and eDP cable through the routing guide on the system board.
8. Connect the eDP cable to the connector on the system board.
9. Connect the display cable to the connector on the system board.
10. Adhere the tape that secures the display cable to the system board.
11. Align the screw holes on the eDP cable bracket with the screw holes on the system board.
12. Replace the two screws (M2x3) that secure the eDP cable bracket to the system board.
70
Removing and installing components
To Next Page
Loading...
