Installing the heat sink assembly for Touch
1 Place the heat sink assembly on the system board and align the heat sink with the screw holders.
2 Tighten the M2x3 screws (4) to secure the heat sink assembly to the system board.
NOTE: Tighten the screws on the system board in the order of the callout numbers [1, 2, 3, 4].
3
Connect the heat sink assembly to the connector on the system board.
4 Install the:
a battery
b base cover
5 Follow the procedure in After working inside your computer.
System fan
Removing the system fan for Non-Touch
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a base cover
b battery
3 To remove the system fan:
a Disconnect the system fan cable from the connector on the system board [1].
b Remove the M2x3 screws (2) that secures the system fan to the system board [2]
NOTE
: Some system may have a integrated heat sink and system fan.
c Lift the system fan away from the system board [3].
32
Disassembly and reassembly
To Next Page
Loading...
