3 To remove the camera:
a Disconnect the camera cable from the connector on the display panel[1].
b Carefully pry and lift the camera module from the display back cover [2].
Installing camera
1 Insert the camera into the slot on the display back cover.
2 Connect the display cable to the connector.
3 Ax the two conductive tape above the camera.
4 Install the :
a display panel
b display bezel
c display assembly
d WLAN
e WWAN card
f memory module
g battery
h base cover
5 Follow the procedure in After working inside your computer.
58
Disassembly and reassembly
To Next Page
Loading...
