Dell latitude e5270 - Installing the WWAN Card; Removing the Power Connector Port

Installing the WWAN card
1. Insert the WWAN card into the slot on the computer.
2. Route the WWAN cables through the routing channel.
3. Connect the WWAN cables to the connectors on the WWAN card.
4. Tighten the screw to secure the WWAN card to the computer
5. Install the:
a. battery
b. base cover
6. Follow the procedure in After working inside your computer.
Removing the power connector port
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. base cover
b. battery
c. dock frame
3. To remove the power connector port:
a. Remove the screw to release the metal bracket on the power connector port [1].
b. Lift the metal bracket from the computer [2].
c. Remove the power connector port from the computer [3].
d. Disconnect the power connector port cable from the computer [4].
17