Installing the speakers
1. Place the speakers into the slots on the computer.
2. Place the LED board.
3. Tighten the screws to secure the LED board to the computer.
4. Route the speaker cable through the retention clips through the routing channel.
5. Connect the speaker cable to the connector on the system board.
6. Install the:
a. dock frame
b. WLAN
c. WWAN
d. hard drive assembly or M.2 SSD or PCIe SSD
e. battery
f. base cover
7. Follow the procedure in After working inside your computer.
Removing the system board
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. base cover
b. battery
c. memory
d. hard drive assembly or M.2 SSD or PCIe SSD
e. keyboard
f. dock frame
g. WLAN
h. WWAN
i. heat sink assembly
j. power connector port
3. To remove the system board:
a. Lift the latch and disconnect the touch pad and system board cable from the computer [1, 2].
b. Disconnect the speaker cable and eDP cable from the system board [3].
28
To Next Page
Loading...
