2. Connect the I/O daughter board FFC the connector on the I/O board.
3. Connect the I/O daughter board FFC the connector on the system board.
Next steps
1. Install the fan.
2. Install the base cover.
3. Install the SD card.
4. Follow the procedure in After working inside your computer.
Hard drive assembly
Removing the hard drive
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the SD card.
3. Remove the base cover.
About this task
The following images indicate the location of the hard drive and provide a visual representation of the removal procedure.
Removing and installing components
43