Installing the Coin-Cell Battery
Installing The Coin-Cell Battery
1. Place the coin-cell battery into its slot on the system board.
2. Press the coin-cell battery downwards till it is secured.
3. Install the front bezel.
4. Install the cover.
5. Follow the procedures in After Working Inside Your Computer.
Related Links
Removing the Coin-Cell Battery
Removing the Power-Switch Cable
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the cover.
3. Remove the front bezel.
4. Remove the drive cage.
5. Disconnect the power-switch cable from the system board.
6. Unthread the power-switch cable from the chassis clip.
7. Pry the power-switch cable away from the chassis.
21
To Next Page
Loading...
