Installing The System Fan
1. Insert the four grommets into the system fan.
2. Place the system fan in the chassis.
3. Pass the four grommets through the chassis and slide outward along the grooves to secure them in place.
4. Connect the fan cable to the system board.
5. Install the fan shelter.
6. Install the drive cage.
7. Install the front bezel.
8. Install the cover.
9. Follow the procedures in After Working Inside Your Computer.
Related Links
Removing the System Fan
Removing The Input/Output (I/O) Panel
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the cover.
3. Remove the front bezel.
4. Remove the drive cage.
5. Unthread the I/O panel or the FlyWire cable from the fan-shelter clip and heat sink.
6. Disconnect the I/O panel or the FlyWire cable from the system board.
7. Remove the single screw that secures the I/O panel to the chassis.
24
To Next Page
Loading...
