Dell OptiPlex 3010 Small Form Factor - Installing the Power-Switch Cable; Removing the System Fan

8. Slide the power-switch cable out through the front of the computer.
Related Links
Installing the Power-Switch Cable
Installing the Power-Switch Cable
1. Slide the power-switch cable in through the front of the computer.
2. Secure the power-switch cable to the chassis.
3. Thread the power-switch cable into the chassis clip.
4. Connect the power-switch cable to the system board.
5. Install the drive cage.
6. Install the front bezel.
7. Install the cover.
8. Follow the procedures in After Working Inside Your Computer.
Related Links
Removing the Power Switch Cable
Removing the System Fan
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the cover.
3. Remove the front bezel.
4. Remove the drive cage.
5. Remove the fan shelter.
6. Disconnect the fan cable from the system board.
22