Dell OptiPlex 3010 Small Form Factor - Page 23

63 pages

To Next Page

To Previous Page

7. Slide the grommets inward along the groove and pass through the chassis.

8. Lift and remove the system fan from the computer.

9. Pry up the grommets from the system fan and remove it.

Related Links

Installing the System Fan

Main Page

Table of Contents3
การทํ า งานกั บ ส่ ว นประกอบภายในของคอมพิ ว เตอร7
การดํ า เนิ น การกั บ ส่ ว นประกอบภายในคอมพิ ว เตอร7
Turning off Your Computer8
หลั ง จากทํ า งานกั บ ส่ ว นประกอบภายในของคอมพิ ว เตอร8
การถอดและติ ด ตั ้ ง ส่ ว นประกอบต่ า ง ๆ9
Removing the Cover9
Installing the Cover9
Removing the Front Bezel10
Installing the Front Bezel10
Removing the Expansion Card10
Installing the Expansion Card11
Removing the Optical Drive12
Installing the Optical Drive12
Removing the Hard Drive13
Installing the Hard Drive14
Removing the Memory14
Installing the Memory15
Removing the Chassis Intrusion Switch15
Installing the Intrusion Switch16
Removing the Speaker16
Installing the Speaker17
Removing the Heat Sink and Processor18
Installing the Heat Sink and Processor20
Removing the Coin-Cell Battery20
Installing the Coin-Cell Battery21
Removing the Power-Switch Cable21
Installing the Power-Switch Cable22
Removing the System Fan22
Installing the System Fan24
Removing the Input/Output (I/O) Panel24
Installing the Input/Output (I/O) Panel25
Removing the Power Supply26
Installing the Power Supply27
Removing the System Board28
Installing the System Board29
Removing the Drive Cage30
Installing the Drive Cage31
Removing the Fan Shelter31
Installing the Fan Shelter32
การตั ้ ง ค่ า ระบบ33
System Setup33
Boot Menu33
Boot Menu Enhancements33
Timing Key Sequences34
Beep Codes and Text Error Messages34
Navigation34
System Setup Options35
การแก้ ไ ขปั ญ หา43
Diagnostic Leds43
Diagnostic Light Patterns43
Beep Codes49
Error Messages51
Address Mark Not Found51
Alert! Previous Attempts at Booting this System Have Failed at Checkpoint [Nnnn]. for Help in Resolving this Problem, Please Note this Checkpoint and Contact Dell Technical Support51
Alert! Security Override Jumper Is Installed51
Attachment Failed to Respond51
Bad Command or File Name51
Bad Error-Correction Code (ECC) on Disk Read51
Controller Has Failed52
Data Error52
Decreasing Available Memory52
Diskette Drive 0 Seek Failure52
Diskette Read Failure52
Diskette Subsystem Reset Failed52
Gate A20 Failure52
General Failure52
Hard-Disk Drive Configuration Error52
Hard-Disk Drive Controller Failure53
Hard-Disk Drive Failure53
Hard-Disk Drive Read Failure53
Invalid Configuration Information-Please Run SETUP Program53
Invalid Memory Configuration, Please Populate DIMM153
Keyboard Failure53
Memory Address Line Failure at Address, Read Value Expecting Value53
Memory Allocation Error53
Memory Data Line Failure at Address, Read Value Expecting Value53
Memory Double Word Logic Failure at Address, Read Value Expecting Value54
Memory Odd/Even Logic Failure at Address, Read Value Expecting Value54
Memory Write/Read Failure at Address, Read Value Expecting Value54
Memory Size in CMOS Invalid54
Memory Tests Terminated by Keystroke54
No Boot Device Available54
No Boot Sector on Hard-Disk Drive54
No Timer Tick Interrupt54
Non-System Disk or Disk Error54
Not a Boot Diskette55
Plug and Play Configuration Error55
Read Fault55
Requested Sector Not Found55
Reset Failed55
Sector Not Found55
Seek Error55
Shutdown Failure55
Time-Of-Day Clock Stopped55
Time-Of-Day Not Set-Please Run the System Setup Program55
Timer Chip Counter 2 Failed56
Unexpected Interrupt in Protected Mode56
EIDE Controller Is Operating Outside of Normal Specifications. It Is Advisable to Immediately Back up Your Data and Replace Your Hard Drive by Calling Your Support Desk or Dell56
Write Fault56
Write Fault on Selected Drive56
Is Not Accessible. the Device Is Not Ready56
รายละเอี ย ดทางเทคนิ ค57
Specification57
การติ ด ต่ อ กั บ Dell63
Contacting Dell63

Dell OptiPlex 3010 Small Form Factor - Page 23

Table of Contents

Related product manuals