Dell OptiPlex 3040 - Installing the SD Card Reader; Removing the Memory Module

a. Disconnect the SD card reader cable from the connector on the system board [1].
b. Remove the screw that secures the SD card reader to the computer [2].
c. Lift the SD card reader out of the computer [3].
Installing the SD card reader
1. Insert the SD card reader into the slot on the system board.
2. Tighten the screw to secure the SD card reader to the system board
3. Connect the SD card reader cable to the connector on the system board.
4. Close the front bezel door.
5. Install the:
a. bezel
b. cover
6. Follow the procedure in After Working Inside Your Computer.
Removing the memory module
1. Follow the procedure in Before Working Inside Your Computer.
2. Remove the:
• cover
• bezel
3. Open the front bezel door.
4. To remove the memory module:
a. Press the memory module retention tabs on both sides of the memory module.
b. Lift the memory module from the memory module connector on the system board.
14