Steps
1. Slide the hard drive into the hard-drive caddy.
2. Install the two (6x32) screws to secure the hard drive to the hard-drive caddy.
3. Place the tabs on the right side of the hard-drive caddy onto the holders on the chassis and push the left side of the caddy
down.
NOTE: Use the arrows seen on the caddy as guides to identify the tabs on the tray.
4. Install the two (6x32) screws to secure the hard-caddy to the hard-drive and optical-drive cage.
Next steps
1. Install the front bezel.
2. Install the side cover.
3. Follow the procedure in after working inside your computer.
Hard-drive and optical-drive module
Removing the hard-disk drive and optical-disk drive module
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the Side cover
3. Remove the Front bezel
Field service information
31
To Next Page
Loading...
