Dell OptiPlex 3080 Small Form Factor - Installing the Intrusion Switch; Optional I;O Modules (Type C; Hdmi;Vga;Dp;Serial); Removing Optional I;O Modules (Type C; Hdmi;Vga;Dp;Serial)

To Next Page

To Previous Page

Installing the intrusion switch

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following images indicate the location of the intrusion switch and provides a visual representation of the installation

procedure.

Steps

1. Insert the intrusion switch into its slot and slide the switch to secure it into the slot.

2. Connect the intruder cable to the connector on the system board.

Next steps

1. Install the fan duct.

2. Install the side cover.

3. Follow the procedure in after working inside your computer.

Optional I/O modules (Type C/ HDMI/VGA/DP/Serial)

Removing optional I/O modules (Type C/ HDMI/VGA/DP/Serial)

Prerequisites

1. Follow the procedure in before working inside your computer.

2. Remove the side cover.

3. Remove the front bezel.

4. Remove the chassis fan.

5. Remove the fan duct.

Field service information

Other manuals for Dell OptiPlex 3080 Small Form Factor