About this task
The following image indicates the location of the VR heat sink and provides a visual representation of the installation procedure.
Steps
1. Place the heat sink on the processor.
2. Tighten the captive screws that secure the heat-sink to the system board and connect the heat sink fan cable to the system
board.
Next steps
1. Install the front bezel.
2. Install the side cover.
3. Follow the procedure in after working inside your computer.
Coin-cell battery
Removing the coin-cell battery
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the front bezel.
About this task
The following images indicate the location of the coin-cell battery and provide a visual representation of the removal procedure.
Field service information
45
To Next Page
Loading...
