NOTE: The pin-1 corner of the processor has a triangle that aligns with the triangle on the pin-1 corner on the processor
socket. When the processor is properly seated, all four corners are aligned at the same height. If one or more corners of
the processor are higher than the others, the processor is not seated properly.
2. When the processor is fully seated in the socket, close the processor cover.
3. Press down and push the release lever under the securing tab to lock it.
Next steps
1. Install the heat sink.
2. Install the fan assembly.
3. Install the side cover.
4. Follow the procedure in after working inside your computer.
System board
Removing the system board
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the hard drive assembly.
4. Remove the solid-state drive.
5. Remove the WLAN card.
6. Remove the fan assembly.
7. Remove the heat sink.
8. Remove the memory modules.
9. Remove the speaker.
10. Remove the optional IO module.
11. Remove the processor.
About this task
The following images indicate the location of the system board and provide a visual representation of the removal procedure.
Removing and installing components
47
To Next Page
Loading...
