Steps
1. Insert the slim ODD assembly into the ODD slot.
2. Slide the slim ODD assembly until it snaps into place.
3. Route the power cable and data cable through the routing guides and connect the cables to the slim ODD.
Next steps
1. Install the fan duct.
2. Install the side cover.
3. Follow the procedure in after working inside your computer.
Slim optical-drive bracket
Removing the slim-ODD bracket
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the fan duct.
4. Remove the slim Optical Disk Drive.
About this task
The following images indicate the location of the slim-ODD bracket and provides a visual representation of the removal
procedure.
Removing and installing components
43
To Next Page
Loading...
