Installing the system board
1. Hold the system board by its edges, and align it towards the back of the system.
2. Lower the system board into the system chassis until the connectors at the back of the system board align with the slots on the
chassis, and the screw holes on the system board align with the standoffs on the system chassis
[1,2].
3. Replace the standoff single (#6-32) screw, the single screw used as a mounting point for M.2 SSD drive and the 5 screws that secure
the system board to the system [1, 2, 3][1,2].
62
Removing and installing components
To Next Page
Loading...
