Dell OptiPlex 7040-Small Form Factor - Page 38

Table 6. General (continued)
Option Description
● Device Information: Displays SATA-0, LOM MAC Address, Video Controller, Audio
Controller, Wi-Fi Device, and Bluetooth Device.
Boot Sequence Allows you to specify the order in which the computer attempts to find an operating system
from the devices specified in this list.
● Legacy
● UEFI
Advanced Boot Options Allows you to select the Enable Legacy Option ROMs option, when in UEFI boot mode. By
default, this option is enabled.
Date/Time Allows you to set the date and time settings. Changes to the system date and time take
effect immediately.
Table 7. System configuration
Option Description
Integrated NIC Allows you to control the on-board LAN controller. The options are:
● Disabled
● Enabled (default)
● Enabled w/PXE
● Enabled w/Cloud Desktop
NOTE: Depending on the computer and its installed devices, the items listed in this
section may or may not appear.
WIDI Allows you to connect to display through WiFi. WIDI requires Intel WiFi card, Intel graphics,
and WIDI receiver in display (or WIDI compliant display). To install the WIDI application, see
the Dell.com/support site to download the WIDI application.
NOTE: When installing the WIDI application, connect the display to Intel onboard graphic
output.
Serial Port Allows you to determine how the built-in serial port to operate. The options are:
● Disabled
● COM 1 – Default setting
● COM 2
● COM 3
● COM 4
SATA Operation Allows you to configure the operating mode of the integrated hard drive controller.
● Disabled = The SATA controllers are hidden
● ATA = SATA is configured for ATA mode
● RAID ON = SATA is configured to support RAID mode
Drives Allows you to enable or disable the various drives on-board:
● SATA-0
● SATA-1
● SATA-2
Smart Reporting This field controls whether hard drive errors for integrated drives are reported during system
startup. This option is disabled by default.
USB Configuration Allows you to enable or disable the integrated USB controller for:
● Enable Boot Support
● Enable Front USB Ports
● Enable Rear USB Ports
All the options are enabled by default.
Front USB Configuration Allows you to enable or disable the front USB ports. All the ports are enabled by default.
Back USB Configuration Allows you to enable or disable the back USB ports. All the ports are enabled by default.
38 System Setup