Table 16. Maintenance (continued)
Option Description
Dell Development Configuration Allows you to turn on/off certain features to control the BIOS. This option is disabled by
default.
BIOS Downgrade Allows you to control flashing of the system firmware to the previous versions. This option is
enabled by default.
NOTE: If this option is not selected, the flashing of the system firmware to the previous
versions is blocked.
Data Wipe Allows you to securely erase the data from all the available internal storages, such as HDD,
SSD, mSATA, and eMMC. This option is disabled by default.
BIOS recovery Allows you to recover the corrupted BIOS conditions from the recovery files on the primary
hard drive or an external USB key.
Table 17. Cloud desktop
Option Description
Server Lookup Method Allows you to specify how the cloud desktop software will lookup server addresses.
● Static
● DNS (Default)
Server Name Allows you to specify the name of the server
Server IP Address Specifies the primary static IP address of the cloud desktop server. The default IP address is
255.255.255.255
Server port Specifies the primary port of the cloud desktop. The default setting is 06910.
Client Address Method Specifies how the client will obtain the IP address.
● Static IP
● DHCP (Default)
Client IP address Specifies the static IP address of the client. The default IP address is 255.255.255.255
Client Subnet Mask Specifies the subnet mask address of the client. The default IP address is 255.255.255.255
Client Gateway Specifies the gateway address of the client. The default IP address is 255.255.255.255
DNS IP Address Specifies the DNS IP address of the client. The default IP address is 255.255.255.255
Domain Name Specifies the domain name of the client.
Advanced Allows you to turn on the Verbose mode for advanced debugging. This option is disabled by
default.
Table 18. System logs
Option Description
BIOS Events Displays the system event log and allows you to:
● Clear Log
● Mark all Entries
Table 19. Advanced configurations
Option Description
ASPM Allows you to activate the state power management.
● Auto (Default)
● Disabled
● L1 Only
System Setup 43
To Next Page
Loading...
