Dell OPTIPLEX 740 - Page 213


Badcommandorfilename— Ensure that you spelled the command correctly, put spaces in the proper place, and used the correct
pathname.

Bad error-correctioncode(ECC)ondiskread— See Drive Problems.

Controllerhasfailed— See Drive Problems.

Dataerror— See Drive Problems.

Decreasingavailablememory—
See Lockups and Software Problems.

Diskettedrive0seekfailure— See Drive Problems.

Diskettereadfailure—
See Drive Problems.

Diskettesubsystemresetfailed— Run the Dell Diagnostics (see Dell Diagnostics).

Diskettewriteprotected— Slide the write-protect notch on the floppy disk to the open position.

Drivenotready— Put a floppy disk in the drive.

GateA20failure—
See Lockups and Software Problems.

Hard-diskconfigurationerror— 

Hard-diskcontrollerfailure— 

Hard-diskdrivefailure— 

Hard-diskdrivefailure—

See Drive Problems.

Insertbootablemedia— Insert a bootable floppy disk or CD.

Invalid configuration information -pleaserunSETUPprogram— Enter system setup and correct the computer configuration information
(see Entering System Setup).

Keyboardfailure— See Keyboard Problems.

Memory address line failure at address, read value expecting value — See Lockups and Software Problems.

Memoryallocationerror—

1. Turn off the computer, wait 30 seconds, and then restart the computer.
2. Try to run the program again.
3. If the error message appears again, see the software documentation for additional troubleshooting suggestions.