Dell OptiPlex 9020 - System Configuration

Dell - Internal Use - Confidential
33 Room for text | Dell Inc., 2014
Card
External Connector
Type
RJ45
N/A
Data Rates Supported
10/100/1000 Mbps Half/Full duplex
N/A
Controller Details
Controller Bus
Architecture
PCIe c1.0a x1
N/A
Integrated Memory
64KBytes RX, 8KBytes TX
N/A
Data Transfer Mode
(example: Bus-Master
DMA)
Bus-Master DMA
N/A
Power Consumption
(full operation per data
rate connection speed)
2.84W (860mA @ +3.3V)
N/A
Power Consumption
(standby operation)
Less than 300mW
N/A
IEEE Standards
Compliance
802.3, 802.2, 802.3x, 802.1p
N/A
Hardware Certifications
FCC B, VCCI B, CE
N/A
Boot ROM Support
No
N/A
Network Transfer Mode
Network
Transfer Rate (example
10BASE-T (half-duplex)
10 Mbps
10BASE-T (full-duplex)
20 Mbps
100BASE-TX (half-
duplex) 100 Mbps
100BASE-TX (full-
duplex) 200 Mbps
1000BASE-T (full-
duplex) 2000 Mbps
10BASE-T (full-duplex) 20 Mbps Max*
100BASE-TX (half-duplex) 100 Mbps Max*
100BASE-TX (full-duplex) 200 MbpsMax*
1000BASE-T (full-duplex) 2000 Mbps Max*
* Depends on the system environment.
N/A
Environmental
Operating Temperature
0° C to 55° C (32° F - 131° F)
N/A
Operating Humidity
5% ~ 95% (non-condensing)
N/A
Operating System
Driver Support
Windows 7 32/64, Windows 8 32/64, Linux
N/A
Manageability
WOL, PXE2.1, ACPI
N/A
Management
Capabilities Alerting
N/A
N/A
1
This term does not connote an actual operating speed of 1 Gb/sec. For high speed transmission, connection to a Gigabit
Ethernet server and network infrastructure is required.
1394 Firewire PCI Add-in Card
MT
Connector Type
IEEE1284-1394a-2000 (6 pins)