EasyManua.ls Logo

Dell OptiPlex GX260 Series - Page 12

Dell OptiPlex GX260 Series
30 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Solving Problems: Dell OptiPlex GX260 Systems User's Guide
Data error The floppy or hard drive cannot read the data.
For the Windows operating system, run the chkdsk utility to check the file structure
of the floppy or hard drive.
For another operating system, run the appropriate corresponding utility.
See your operating system documentation for information on running these utilities.
Decreasing available memory One or more memory modules may be faulty or
improperly seated.
Reinstall the memory modules and, if necessary, replace them (see "Memory" for
module installation procedures).
See "Memory Problems" for additional troubleshooting suggestions.
Diskette drive 0 seek failure A cable may be loose or the computer configuration
information may not match the hardware configuration. See "
Drive Problems" for
troubleshooting suggestions.
Diskette read failure The floppy disk may be defective or a cable may be loose.
If the drive access light turns on, try a different disk.
See "Drive Problems" for troubleshooting suggestions.
Diskette subsystem reset failed The floppy drive controller may be faulty. Run the
Dell Diagnostics.
Drive not ready No floppy disk is in the drive. Put a floppy disk in the drive.
Diskette write protected The floppy disk is write-protected. Slide the write-protect
notch to the open position.
Gate A20 failure One or more memory modules may be faulty or improperly seated.
Reinstall the memory modules and, if necessary, replace them (see "Memory" for
module installation procedures).
See "Memory Problems" for additional troubleshooting suggestions.
General failure The operating system is unable to carry out the command. This
message is usually followed by specific informationfor example, Printer out of paper.
Take the appropriate action to resolve the problem.
Hard-disk configuration error The hard drive failed initialization.
Run the Dell Diagnostics.
See "Drive Problems" for troubleshooting suggestions.
http://support.dell.com/support/edocs/systems/opgx260/en/ug/solvprob.htm (12 of 30) [10/25/2007 1:44:24 PM]

Other manuals for Dell OptiPlex GX260 Series

Related product manuals