Hard-disk controller failure— The hard drive failed initialization.
● Run the Dell Diagnostics.
● See "Drive Problems" for troubleshooting suggestions.
Hard-disk drive failure— The hard drive failed initialization.
● Run the Dell Diagnostics.
● See "Drive Problems" for troubleshooting suggestions.
Hard-disk drive read failure— The hard drive failed initialization.
● Run the Dell Diagnostics.
● See "Drive Problems" for troubleshooting suggestions.
Invalid configuration information - please run SETUP program— The computer
configuration information does not match the hardware configuration.
Enter system setup
and correct the computer configuration information.
Keyboard failure— A cable or connector may be loose, or the keyboard or keyboard/
mouse controller may be faulty. See "
Keyboard Problems."
Memory address line failure at address, read value expecting value— A memory
module may be faulty or improperly seated. Reinstall the memory modules and, if
necessary, replace them. See "
Memory Problems" for additional troubleshooting
suggestions.
Memory allocation error— The software you are attempting to run is conflicting with the
operating system, another program, or a utility.
1. Turn off the computer, wait 30 seconds, and then restart the computer.
2. Try to run the program again.
3. If the error message still appears, see the software documentation for additional
troubleshooting suggestions.
Memory data line failure at address, read value expecting value— A memory
module may be faulty or improperly seated. Reinstall the memory modules and, if
necessary, replace them. See "
Memory Problems" for additional troubleshooting
suggestions.
Memory double word logic failure at address, read value expecting value— A
memory module may be faulty or improperly seated. Reinstall the memory modules and,
if necessary, replace them. See "
Memory Problems" for additional troubleshooting
suggestions.
http://support.dell.com/support/edocs/systems/opgx260/en/ug/solvprob.htm (13 of 30) [10/25/2007 1:44:24 PM]
To Next Page
Loading...
