Dell OPTIPLEX XE Series - Advanced System Manageability Features; Memory Configurations

DELL™ OPTIPLEX™ XE TECHNICAL GUIDEBOOK V1.0
7
MEMORY
Memory modules should be installed in pairs of matched memory size, speed, and technology. If the memory
modules are not installed in matched pairs, the computer will continue to operate, but with a slight reduction
in performance.
ADVANCED SYSTEM MANAGEABILITY MODES
NOTE: Hardware management mode options allow you to select the right systems management feature support
for your enterprise. Dell’s innovative approach to scalable remote client management offers you a choice of
built-in hardware management capabilities across platform offerings.
The latest generation of Broadcom® TruManage™ technology provides the capability to manage your install
base of systems regardless of the power or O/S state of the system.
This functionality allows IT to address many issues remotely rather than having to physically visit systems.
The OptiPlex™ XE supports Broadcom® TruManage™ technology which supports the following features:
BIOS Management, asset reporting, remote troubleshooting and repair, power on for remote patching/updating.
DT SFF
Broadcom® TruManage™ Systems Management Ready
X X
DT SFF
Type: DDR3 Synch DRAM Non-ECC Memory
1066MHz
DIMM Slots
4 4
DIMM Capacities
Up to 2GB Up to 2GB
Minimum Memory
1GB 1GB
Maximum System Memory (uses 2GB DIMMS)
8GB
1
8GB
1
1066MHz Memory configurations
8GB
1
DDR3 Non-ECC SDRAM, 1066MHz, (4 DIMM) X X
4GB
1
DDR3 Non-ECC SDRAM, 1066MHz, (4 DIMM) X X
4GB
1
DDR3 Non-ECC SDRAM, 1066MHz, (2 DIMM) X X
3GB DDR3 Non-ECC SDRAM, 1066MHz, (3 DIMM) X X
3GB DDR3 Non-ECC SDRAM, 1066MHz, (2 DIMM) X X
2GB DDR3 Non-ECC SDRAM, 1066MHz, (2 DIMM) X X
2GB DDR3 Non-ECC SDRAM, 1066MHz, (1 DIMM) X X
1GB DDR3 Non-ECC SDRAM, 1066MHz, (1 DIMM) X X
1
The total amount of available memory may be less than 4GB. The amount less depends on the actual system configuration. To fully utilize 4GB or
more of memory requires a 64-bit enabled processor and 64-bit operating system.