Dell P1911 - Setting Up the Monitor; Connecting the VGA Cable; Connecting the USB Cable

Connecting the blue VGA cable

Connecting the USB cable
After you have completed connecting the DVI/VGA cable, follow the procedure below to connect the USB cable to the computer and complete your monitor
setup:
1. Connect the upstream USB cable (cable supplied) to the monitor upstream port and then to the appropriate USB port on your computer (see bottom
view for details).
2. Connect USB peripherals to the downstream USB ports (side or bottom) on the monitor. (See side or bottom view for details.)
3. Plugthepowercablesforyourcomputerandmonitorintoanearbyoutlet.
4. Turn on the monitor and the computer.
If your monitor displays an image, installation is complete. If it does not display an image, see Solving Problems.
5. Use the cable holder on the monitor stand to organize the cables.
Organizing Your Cables

NOTE: The Graphics are used for the purpose of illustration only. Appearance of the computer may vary.