Setting up the monitor │ 31
Setting up the monitor
Attaching the stand
NOTE: The stand is not installed at the factory when shipped.
NOTE: The following instructions are applicable only for attaching the
stand that was shipped with your monitor. If you are attaching a stand
that you purchased from any other source, follow the set up
instructions that were included with the stand.
To attach the monitor stand:
1. F
ollow the instructions on the flaps of carton to remove the stand from the
top cushion that secures it.
2. Inse
rt the stand base blocks fully into the stand slot.
3. L
ift the screw handle and turn the screw clockwise.
4. A
fter fully tightening the screw, fold the screw handle flat within the recess.
To Next Page
