Dell POWERCONNECT 6200 SERIES - Page 131

Device Security 131
Example 7: Modify the Default Captive Portal Configuration (Change Verification Method to Local)
To change the verification method to local, use the following command:
console(config-CP 1)#verification local
To view the configuration change, use the following command:
console#show captive-portal configuration 1 status
CP ID.......................................... 1
CP Name........................................ Default
CP Mode........................................ Enable
Protocol Mode.................................. HTTP
Verification Mode.............................. Local
Group ID....................................... 1
Group Name..................................... Default
User Logout Mode............................... Enable
URL Redirect Mode.............................. Disable
Session Timeout................................ 0
Idle Timeout................................... 0
Max Bandwidth Up (bytes/sec)................... 0
Max Bandwidth Down (bytes/sec)................. 0
Max Input Octets (bytes)....................... 0
Max Output Octets (bytes)...................... 0
Max Total Octets (bytes)....................... 0