Dell PowerConnect 6224 - Configuration Information

6 Dell PowerConnect 6224 or 6248 | Planning and Preparation Guide | Rapid EqualLogic Configuration Series
2.4 Configuration information
Your iSCSI SAN configuration requires several static IP addresses. Complete this form and have it available
for reference during the configuration.
Table 1 IP addresses needed for configuration:
Host iSCSI Initiator
Host #1
Additional host
…
Port 1
Port 2
Port 3
Port 4
Array Target
Array #1
Additional array
…
Port 1 (eth0)
Port 2 (eth1)
Management
(Out-of-Band or eth2)
Array Group Management IP
(Out-of-Band)
Array Group Management IP
(In-Band)
Switch Management Port
(Out-of-Band)
Switch Admin password: _________________________
Array Group Admin password: __________________________*
Array Membership password: ___________________________*
*These may be the same password – see the PS-series Group Administration guide for more information.