Tower-to-Rack Conversion Guide 9
• Installing the optional 1x2 flex bay bracket
• Installing the shoulder nuts and plastic filler panels
• Removing the rack doors
• Installing the system in the rack
• Installing the cable-management arm
• Routing the system cables
• Installing the rack bezel
• Installing the rack doors
Removing the Bezel
1 Unlock the keylock at the right side of the bezel.
See
Figure 1-2
.
2
While grasping the bezel, push the release latch on top of the bezel to the right.
3
Rotate the top of the bezel away from the front panel.
4
Unhook the bottom of the bezel and pull the bezel away from the system.
See
Figure 1-2
.
book.book Page 9 Friday, May 26, 2006 3:03 PM
To Next Page