16 Rack Installation Guide
Figure 1-7. Installing the System in the Rack
Removing the System From the Rack
To remove the system from the rack, perform the following procedure:
1
Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
2
Remove the I/O cable connectors and power cable connectors from their respective connectors
on the system back panel.
3
Loosen the thumbscrews on each side of the front chassis panel that secures the system to the rack.
1 slide-release latch 2 shoulder screws (6) 3 J slots (6)
4 front release latch
1
2
4
3
To Next Page
Loading...
