Rack Installation Guide 17
4
Pull the system out of the rack until it stops because of the safety catch.
5
Pull up on the front release latch on each rail to disengage the safety catch (see Figure 1-7) and slide
the system forward.
6
Pull the system completely out of the rack.
Installing the Cable-Management Arm
NOTE: You can attach the
cable-management arm to either side of the rack cabinet.
NOTE: Attach the
cable-management arm ramp assembly to the side opposite of where you attach the cable-
management arm.
1
Fit the latch on the front end of the cable-management arm onto the bracket on the end of the
mounting rail until the latch clicks (see Figure 1-8).
2
Fit the latch on the unattached end of the cable-management arm onto the bracket on the end of the
slide assembly until the latch clicks (see Figure 1-8).
CAUTION: Both ends of the cable-management arm must be connected before you begin routing the system
cables
.
Figure 1-8. Installing the Cable-Management Arm
1 mounting rails (2) 2 brackets (2)
3 latches (2) 4 cable-management arm
back of system
1
2
4
3
To Next Page
Loading...
