Upgrading the Computer With Additional Power Supplies C-3
10. Install the PSPB onto the PSPB tray (see Figure C-2):
a. While holding the PSPB by its edges, position the PSPB so that the tabs on
the PSPB tray fit through the corresponding slots in the PSPB.
b. Slide the PSPB toward the front of the tray a quarter of an inch (about one
centimeter).
c. Secure the PSPB by tightening the captive screw.
)LJXUH&,QVWDOOLQJWKH363%2QWRWKH363%7UD\
11. Connect the three Y power cables to the PSPB.
Attach the pair of cables leading from each Y power cable connector to the corre-
sponding two connectors on the PSPB.
12. Reinstall the PSPB tray in the chassis.
13. Secure the tray with the screw you removed in step 6.
14. Attach the 4-conductor power cable to the external-drive power cable connector
(labeled “FD”) on the PSPB (see Figure C-3) and to the drives in the external
drive bays.
PSPB
PSPB tray
captive screw
To Next Page
Loading...
