C-4 Dell PowerEdge 4300 Systems Installation and Troubleshooting Guide
)LJXUH&2SWLRQDO363%
15. Attach the nine-conductor power cable labeled “HDBP” to the SCSI backplane
board power cable connector (HD_B/P) on the PSPB and to the power connector
(POWER) on the SCSI backplane board.
16. Attach the system-board power cables labeled “PWR1” and “PWR2” to the cor-
responding connectors on the PSPB and system board (see Figure 8-1 and
Figure C-3).
See Table C-1 for the location of the connectors on the two boards.
system-board
power cable
connector (PWR2)
system-board
power cable
connector (PWR1)
(not used)
SCSI backplane
board power cable
connector (HD_B/P)
external-drive power
cable connector (FD)
cable connectors
(power supply #1)
cable connectors
(power supply #2)
cable connectors
(power supply #3)
To Next Page
Loading...
