Dell POWEREDGE 4300 - SCSI Bus Interface Definitions; Boot Device Options; SCSI Device;Configuration Settings

3-4 Dell PowerEdge 4300 Systems User’s Guide
NOTE: The SCSI
Select
Utility must be run for both the AIC-7890 and the AIC-7860
SCSI controllers if you need to change the configuration settings.
To change any of the defaults, see “Configure/View Host Adapter Settings” found ear-
lier in this chapter. To format or verify a disk, see “SCSI Disk Utilities” found earlier in
this chapter.
7DEOH6&6,&RQWUROOHU'HIDXOWV
2SWLRQ
'HIDXOWIRU
$,& 
+RVW$GDSWHU
'HIDXOWIRU
$,&DQG
8:
+RVW$GDSWHUV
SCSI Bus Interface Definitions:
Host Adapter SCSI ID 7 7
SCSI Parity Checking Enabled Enabled
Host Adapter SCSI Termination Enabled Enabled
Boot Device Options:
Boot Target ID 0 0
Boot LUN Number 0 0
SCSI Device/Configuration Settings:
Initiate Sync Negotiation Yes Yes
Maximum Sync Transfer Rate (MB/sec) 20 80
Enable Disconnection Yes Yes
Initiate Wide Negotiation N/A Yes
Send Start Unit Yes Yes
BIOS Multiple LUN Support Yes No
Include in BIOS Scan Yes Yes
NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary.
33255bk0.book Page 4 Tuesday, August 25, 1998 8:46 AM