Dell POWEREDGE 4300 - Main Menu; Learn about Configuring Your Computer; Configure Computer; Set Date

5-4 Dell PowerEdge 4300 Systems User’s Guide
Follow these steps the first time you use the RCU. Later, if a card is added, removed,
or repositioned, you must follow the procedure described in “Step 2: Add or Remove
Boards” found later in this chapter.
1.
To run the program from a diskette
, insert into the diskette drive the RCU diskette
that you created from the
Dell Server Assistant
CD. Then either turn on your com-
puter or reboot it by pressing <Ctrl><Alt><Del>.
To run the program from your hard-disk drive
, switch to the c:\rcu subdirectory,
type
sd
at the operating system prompt, and press <Enter>.
To run the program from the
Dell Server Assistant
CD
, restart the system from
the CD. Select Configure System and then select Run RCU from the CD’s main
menu.
2. When the Welcome screen appears, read the information on the screen and
press <Enter>.
The Main Menu appears as follows:
Main Menu
Learn about configuring your computer
Configure computer
Set date
Set time
Maintain resource configuration diskette
Exit from this utility
The first option in the menu is already highlighted.
3. Press <Enter> to read the online overview of the RCU.
After reading the online overview, you are ready to use the program to configure
your computer for any PCI expansion cards currently installed in your computer’s
expansion slots.
0DLQ0HQX
The following sections describe each of the menu options in the Main Menu.
/HDUQ$ERXW&RQILJXULQJ<RXU&RPSXWHU
Learn about configuring your computer presents an overview of the configuration
process. As you finish reading a screen, press <Enter> to view the next screen. Press
<F10> to return to the Main Menu.
&RQILJX UH&RPSXWHU
Configure computer takes you through the configuration process step by step. Use
this option the first time you configure your system and every time you change your
33255bk0.book Page 4 Tuesday, August 25, 1998 8:46 AM